M14 Services
I have been building these rifles for over 25 years. I have
always tried to incorporate the best in what I built. I feel
that the rifles I offer are state of the art and are some of the
most dependable and accurate available.
Springfield Basic Rifle Tune-up
$175.00
This package is recommended for basic and "loaded" out of
the box rifles, including bush and scout. The following
modifications have been selected to help improve the accuracy potential of
the rifle.
-
Inspection and Gauging
-
Square & Crown Barrel & Flash Suppressor
-
NM Modify Flash Suppressor
-
NM Spring Guide
-
Check and adjust trigger pull
-
Forend modification
-
Overall fine tuning
-
Test Fire
Inspection and Gauging
$45.00
Adjust Trigger Pull
$45.00
Produces a clean, crisp two-stage pull with a total weight of 4¾ to 5
pounds.
|
? Why is the trigger pull set at 5 pounds.
Normally the M14(M1A) trigger has to be at least 4½
pounds to prevent the rifle from doubling and also to meet NM specs.
By initially setting the weight to 5 pounds it allows for parts to wear in
slightly and still maintain a safe margin on the trigger pull weight.
|
Modify Gas Cylinder to NM Specs
$60.00
The gas cylinder and front band are screwed together to produce a unitized
assembly. This provides for a more consistent placement of the front
band on the barrel in relation to the gas cylinder and the stock ferrule.
Square & Crown Barrel & Flash Suppressor
$30.00
This modification insures that the mating surfaces between the barrel
and flash suppressor are as perfect a fit as possible. Uneven gas
release at the muzzle is one of the biggest accuracy problems for these
rifles. (Also performed on Muzzle Brakes)
NM Modify Flash Suppressor
$30.00
Allows expanding gas to escape more easily reducing its influence on
the bullet. Also eliminates contact points between the barrel and
flash suppressor. Four separate dimensions are altered in our
modification process, not just one dimension you typically see
elsewhere.
Modify Muzzle Brake
$15.00
Eliminates contact points between barrel and muzzle brake.
Fit NM Aperture to Sight Base
$20.00
Fit NM Rear Sight Assembly to Receiver
$20.00
Install Scope Mount
$15.00
Stock Bedding
Glass Bed Wood Stock
$175.00
Glass Bed McMillan Stock
$150.00
Stock Ferrule
$15.00
Required for bedding McMillan Fiberglass Stocks.
Add for Rear Lugged Receiver
$40.00
Inlet McMillan Stock for Rear Lug
$20.00
NM
modified stock ferrule. This modification eliminates contact and
pressure points from the gas cylinder.
